Radiomaster R86c V2 receiver airplane 6CH PWM (Frsky LBT)

Description

RadioMaster R86C V2 Receiver is a great choice if you need to drive standard servos (PWM output) from the receiver. e.g. for airplanes. It is compatible with FrSky D16 (EU LBT) protocol. It supports Return RSSI signal strength. Full range.

* Only for Multi-protocol radios. Doesn’t support Frsky transmitters.

Specifications

Channels: 6 channels (PWM), 9 channels (SBUS) (8 control channels + 1 return RSSI signal strength)
Frequency range: 2400-2483.5Mhz
Power input range: PWM 4.5-8.4V, SBUS 4.5-6.6V
Signal format: Frsky D16 EU LBT
Output format: PWM / SBUS
Range: more than 1km
Antenna length: 15cm
Size: 45*21.2*12.7mm
Weight: 8g

RSSI output

This receiver has a total of 6 PWM channels + 9 SBUS Channels (Sbus has 8 control channels + 1 RSSI channel). Channels 1-8 are controlled by the remote controller, the 9th channel is the signal strength RSSI value output by the receiver, which can  be read by various flight controllers and sent to the OSD to Show signal strength in the FPV video feed.

Binding Instructions

1. Turn on your transmitter and select the correct protocol for the Multi-Protocol Module.
   
   • Mode: Multi, FrskyX
   • RF Protocol: LBT(EU)
2. Please keep the Transmitter at least a few feet away from the Receiver.
3. Enter bind mode on the receiver. Press and hold the bind button while powering on the receiver. Red LED will be blinking slowly to indicate binding mode.
   
4. Press bind on the transmitter. Select “Ch 1-8 Telem ON”
   
5. The light will flash rapidly then blink slowly and finally turn steady ON. This completes binding procedure.
   
6. Power OFF and power ON the receiver after binding.

Includes

• R86C V2 Standard receiver
• Instruction leaflet

Downloads

• R86C V2 User manual