Description
OMPHobby 85A ESC for OMPHobby M4 Max Helicopter, OSHM4X023
Telemetry supported by Vbar Control, MSH Brain2 / IKON2, Spirit, RotorFlight, and Futaba SBUS-2.
Vidéos
Features
- 85A continuous and 130A peak current support
- High power 10A BEC regulator (6V, 7.4V, 8.4V*)
- Telemetry support: current, voltage, temperature, RPM, throttle and ESC status code.
- Telemetry protocol: Supported by MSH Brain, RotorFlight, Vbar Control and Futaba SBUS-2
- Supports RPM signal over wire. No need for external RPM sensor.
- The ESC has a separate programming interface to connect a LCD programming card ou Bluetooth module.
- High performance 32-bit microprocessor running at 170MHz
- New generation MOSFET with low heat generation, large burst current withstanding capability and high reliability.
- Self-check function: after the ESC powers on, it will automatically check for short circuit, motor lose phase, non-zero throttle and battery voltage.
- The specially designed ESC case greatly enhances the ESC’s heat dissipation performance.
- There are two Governor modes: Helicopter Governor Store mode (default) and External Governor mode.
- Multiple protection features: abnormal power-on voltage protection, start up protection, temperature protection, throttle signal loss protection, over load protection,low voltage protection, over current protection.
- Firmware update via OMPHobby Bluetooth Module using iOS or Android App.
Caractéristiques
- Max Continuous current: 85A
- Max Peak current: 130A
- Input voltage: 3-6S LiPo
- BEC voltage: 6V/7.4V/8.4V
- BEC current: 10A
- Size: 71x36x33 mm
- Weight: 90g
Connectors
- XT60 for Battery
- 3 Bullets for Motor
- 3-pin Throttle Signal Plug: S (Throttle Signal), + (BEC output), – (Ground)
- 1-pin RPM Signal Plug
- 5-pin Programming Header: TX (Transmit), RX (Receive), + (BEC output), – (Ground)
Comprend
OMPHobby 85A ESC
EN 
FI 
SV 
DA 
DE 
FR
Jacques BAYLOT (client confirmé) –
OMP ESC TELEMETRY Protocol not yet compatible with FRSKY hardware and Ethos software…