Mikado VLink S.BUS Telemetry Receiver for Micro Helis – 05680

Beschreibung

Mikado VLink S.BUS Telemetry Receiver for Micro Helis is must have to get best support for OMP M1 V3 and M2 V3 Helicopters (OFS3 system). This is a RX-Only receiver.

It will also work with other micro helis that support SBUS. e.g. Goosky S1 / S2

Features

• small, lightweight S.BUS compatible receiver, weighs only 4.2 g
• allows operation of micro helis with VBar Control
• full telemetry-support with OMPHOBBY OFS3 (e.g. M1/M2V3)
• antenna diversity
• VBasic/RX Only-Firmware, fully functional
• online updatable
• ‘Indoor Receiver’ for use on small models like micro helis, park flyers, typically not a full range receiver

Instructions

• Connect 3-pin connector to SBUS port on OFS3 controller or any other micro heli controller.
• (optional) Connect 4-pin connector to CRSF port on OFS3 controller. This is required for telemetry only.
• (optional) In OMPHobby app set S.BUS Range to Futaba and Enable VBar Control Telemetry.

Beinhaltet

• Receiver unit
• Manual: Quick-Start-Guide (printed)

Spezifikationen

Dimensions	32 x 18 x 5 mm / 1.26 x .71 x .2 in
Weight	approx. 4.2 g / .15 oz
Supply Voltage	3.5-8.4 V (2s LiPo)

Beinhaltet

Main unit	Multiprotocol Single Line Indoor Receiver (VLink,UDI, S-Bus, PPM)
Gyrosensor	none
Manual	Printed Manual (Quick-Start-Guide)
Software	VBasic Receiver Firmware

Hardware Requirements

• Vbar Control

Downloads

• Mikado Vlink SBUS Telemetry Receiver for Micro Helis – Quick Start Guide.