Radiomaster R86c V2 receiver airplane 6CH PWM (Frsky LBT)

Beskrivelse

RadioMaster R86C V2 Receiver is a great choice if you need to drive standard servos (PWM output) from the receiver. e.g. for airplanes. It is compatible with FrSky D16 (EU LBT) protocol. It supports Return RSSI signal strength. Full range.

* Only for Multi-protocol radios. Doesn’t support Frsky transmitters.

specifikationer

Kanaler: 6 kanaler (PWM), 9 channels (SBUS) (8 control channels + 1 return RSSI signal strength)
Frekvensområde: 2400-2483,5 Mhz
Power input range: PWM 4.5-8.4V, SBUS 4.5-6.6V
Signal format: Frsky D16 EU LBT
Outputformat: PWM / SBUS
Rækkevidde: mere end 1 km
Antenna length: 15cm
Size: 45*21.2*12.7mm
Weight: 8g

RSSI -udgang

Denne receiver har i alt 6 PWM -kanaler + 9 SBUS -kanaler (Sbus har 8 kontrolkanaler + 1 RSSI -kanal). Kanaler 1-8 styres af fjernbetjeningen, den 9. kanal er signalstyrken RSSI-værdi udsendt af modtageren, som kan  læses af forskellige flyvekontrollere og sendes til OSD for at vise signalstyrke i FPV -videofeed.

Binding Instructions

1. Turn on your transmitter and select the correct protocol for the Multi-Protocol Module.
   
   • Mode: Multi, FrskyX
   • RF Protocol: LBT(EU)
2. Please keep the Transmitter at least a few feet away from the Receiver.
3. Enter bind mode on the receiver. Press and hold the bind button while powering on the receiver. Red LED will be blinking slowly to indicate binding mode.
   
4. Press bind on the transmitter. Select “Ch 1-8 Telem ON”
   
5. The light will flash rapidly then blink slowly and finally turn steady ON. This completes binding procedure.
   
6. Power OFF and power ON the receiver after binding.

Inkluderer

• R86C V2 Standard receiver
• Vejledning

Downloads

• R86C V2 User manual