Frsky XM+ / XM PLUS Mini Receiver (16CH SBUS)

Beskrivelse

FrSky XM+ / XM PLUS Mini Receiver is the upgraded version of the ever-popular XM receiver from FrSky. Compared to the XM receiver, the XM+ has the addition of a diversity antenna.

It supports 16 channels over SBUS, failsafe and full range, the XM Plus is compatible with FrSky’s D16/EU LBT mode found on multi-protocol Radio Transmitters.

It is an ideal receiver to be used as a redundant receiver along with other Frsky Receivers like R-XSR and RX8R PRO.

OBS: Please let us know if you want us to install the 3-pin header for you.

Features

• Ultra-light receiver ONLY 1.6g
• 16 Channels
• Full range
• Firmware upgradeable
• RSSI output on CH16
• D16 mode compatible

specifikationer

• Channels: 16Ch (S.Bus) (1-15ch for PWM,16ch RSSI for Flight Controller)
• Voltage: 3.7 ~ 10V
• Operating Current: 30mA @ 5V
• Full Range
• Compatibility: FrSky D16 mode
• Dimension: 21.5 x 12 x 3.5mm
• Weight: 1.6g

Inkluderet:

• 1x FrSky XM+ SBUS Mini Receiver EU LBT
• 2x 3-pin headers (1 right angle, 1 straight)
• 1x Heat Shrink tubing (only @OriginHobbies)

Binding procedure

A) Roll back Multi-Module RF firmware to v1.3.3.20 as later versions have issues binding with XM+ (Multi-protocol Firmware issue #987)

• Download Multi-module firmware v1.3.3.20
  https://github.com/pascallanger/DIY-Multiprotocol-TX-Module/releases/download/v1.3.3.20/mm-stm-serial-aetr-v1.3.3.20.bin
• Copy it to the Firmware directory on the Radio Transmitter’s SD-Card.
• Power up the Radio Transmitter and Flash the firmware into Internal RF module
• Sys->SD-card->Firmware->mm-stm-serial-aetr-v1.3.3.20.bin->Flash Internal Multi

B) Bind TX16S to XM+

• On the Transmitter, Check RF protocol and Receiver ID
  MDL->Internal RF
  Mode = Frsky X2
  RF Protocol = LBT (EU)
  Receiver ID = 2 (pick a unique number that is not used in other models on the Radio)
• (IMPORTANT) Keep the Radio Transmitter at least 3 feet away from the XM+ during binding and operation.
• Hold BIND button when powering up XM+, release button only after both Red and Green LEDs are lit steady.
• on the Transmitter, press the BIND button and choose “CH 1-8 Telem OFF” if being used as redundant receiver “CH 1-8 Telem ON” otherwise.
• when binding is successful the RED led will start blinking and GREEN remains steady.
• Power off and power on the XM+. Green LED should be blinking at a fast rate. This means receiver is bound correctly to the radio.

C) Restore the Multi-module firmware back to the latest version

• Sys->SD-card->Firmware->4in1-FCC-air-v1.3.4.0->Flash Internal Multi

Downloads

• XM+ User Manual