Beschreibung
65A ESC for M4 / 380 size Helicopter for OMPHobby M4 Helicopter, OSHM4050
Telemetry supported by Vbar Control, MSH Brain2 / IKON2, Spirit, RotorFlight, and Futaba SBUS-2.
Videos
Features
- 65A continuous and 100A peak current support
- High power 10A BEC regulator (6V, 7.4V, 8.4V*)
- Telemetry support: current, voltage, temperature, RPM, throttle and ESC status code.
- Telemetry protocol: Supported by MSH Brain, RotorFlight, Vbar Control and Futaba SBUS-2
- Supports RPM signal over wire. No need for external RPM sensor.
- The ESC has a separate programming interface to connect a LCD programming card oder Bluetooth module.
- High performance 32-bit microprocessor running at 170MHz
- New generation MOSFET with low heat generation, large burst current withstanding capability and high reliability.
- Self-check function: after the ESC powers on, it will automatically check for short circuit, motor lose phase, non-zero throttle and battery voltage.
- The specially designed ESC case greatly enhances the ESC’s heat dissipation performance.
- There are two Governor modes: Helicopter Governor Store mode (default) and External Governor mode.
- Multiple protection features: abnormal power-on voltage protection, start up protection, temperature protection, throttle signal loss protection, over load protection,low voltage protection, over current protection.
- Firmware update via OMPHobby Bluetooth Module using iOS or Android App.
Spezifikationen
- Max Continuous current: 65A
- Max Peak current: 100A
- Input voltage: 3-6S LiPo
- BEC voltage: 6V/7.4V/8.4V
- BEC current: 10A
- Size: 60x36x18.5 mm
- Weight: 65g
Connectors
- XT60 for Battery
- MR60 for Motor
- 3-pin Throttle Signal Plug: S (Throttle Signal), + (BEC output), – (Ground)
- 1-pin RPM Signal Plug
- 5-pin Programming Header: TX (Transmit), RX (Receive), + (BEC output), – (Ground)
Downloads
Accessories (not included)
Beinhaltet
- 65A ESC-1
EN 
FI 
SV 
DA 
DE 
FR
Anonym (Verifizierter Käufer) –
Overall, I am very satisfied